Mounting kit 2E-VH for Loxone Intercom NEW with NFC CodeTouch. Rear assembly in sheet steel products. Consists of front panel, housing shell, screw set.
With this variant, the intercom with Codetouch can be used flush in V2A stainless steel assemblies such as letter boxes, house doors or steel bars.
For this purpose, a rectangular cutout is to be made in the steel structure; 4 welding studs are to be placed on the rear of the steel plate for fastening.
The component must be accessible from the rear / inside, e.g. via an inspection flap, so that assembly and connection can be carried out.
The 2 single frames required for the new intercom and a code touch are not included in our scope of delivery.
On the back, a housing shell is plugged into the front, into which the mounting frames available from Loxone can be mounted directly.
The housing shell hermetically seals the unit and directs the loudspeaker sound to the front through the left slot on the front panel.
The right slot is used for a symmetrical look.There is a predetermined breaking point in the middle of each module position, which you break open as required and lead the supply line through. Here, too, you can additionally seal with acrylic after the cables have been routed.
The Codetouch generation 1 differs from the installation height. To compensate for this difference in height, we can supply a 0.3 mm PVC film on request, which is mounted under the PVC wall bracket of the old Codetouch. The foil must not be used when using the new Codetouch.
Additional Information
| Weight | 600 g |
|---|---|
| size | 260 × 150 × 8 mm |
| Dimensions | 100 x 210 mm, installation depth 13 mm |
| Attachment | With 4 welding studs which must be attached to the back of the V2A |
| scope of delivery | 8 countersunk screws for fastening the Loxone frame in the housing shell |
Custom-made products and cannot be exchanged!
